开云体育

I have the 6 files, all quite large so I shall send them on in separate emails later this evening. 73 ... Sid. -- Sid Boyce ... Hamradio License G3VBV, Licensed Private Pilot Emeritus IBM/Amdahl

John There is this http://www.wb5rvz.com/sdr/mobo43/ Were they in the Files section? They should have been duplicated in the transfer. I think the Mobo also had their own group, do not know if still

I am also looking for them, thanks, Paul K0ZYV

Arrow's Varical is a Mitsubishi distributor and should have them. But (there always is one) usually will only sell in the smallest factory pkg. IIRC the RD06 minimum was 34 pieces. 73, -Bob ah7i

The builder's notes are not in Files anymore; does anyone have them? Thanks 73 John VE3NFK (I have an unbuilt kit)

Hi Howard, No, I have not heard from the company yet. I may start inquiring to find out the status. I shall let you know asap. Regards Ed.

Hi Ed: Just following up with you to see if you have gotten your Odroid N2+ and checked out its operation. Thanks, Howard

Hello All, Just to let group know, Zack W9SZ had an exceptional showing in the SE VHF 2020 Fall Sprint Contest as a microwave rover. Making amateur microwave equipment work on a bench or in the

Generally speaking attic antennas will pick up more noise than outdoor antennas so I would not expect the SNR to be as good. But I would have thought your attic dipole would be receiving plenty of

The Softrocks need good TX-type antenna. With any antenna the first question is whether on the frequency of interest does the noise level increase when you connect the antenna? If not a preamp may

A TinySA and a NanoVNA are extremely useful bits of technology. I have both and they are great. Dave W2IJL [email protected]> wrote:

O.O? Nothing I would not suggestion to anyone/everyone.? Sharing my own up hill climb and fun, rank novice amateur ongoing experience.? It is all good.? :) Charles/KC1ENN

Seem to have gone to the list!

Private not public reply.? Invest in an inexpensive NanoVNA and tune your antennas.? Amazing learning tool and improvements in my low power projects.? Ebay/Amazon. Charles

The softrock has been up and running for over a week now thanks in large part to group tips.? However, the antenna I'm using, a 30' long attic dipole isn't doing so well and looking for upgrade

Thanks, guys.? I'm going to try MultiPSK first since it looks like the easiest one to set up.? I should have mentioned that the PC never goes online so hope that doesn't cause program issues.

I use FLdigi to decode CW.

If I recall correctly, both FLdigi and MultiPSK can be used with HDSDR and a SoftRock RX to decode CW.

Just wondering if there was any way to freely decode CW with HDSDR and Softrock RX Ens II? If something other than HDSDR can do it and also free, please share. Thank you.

Hi Shirley, I had exactly the same thought and also wondered at the 3.3V limit which, if I calculate correctly is about 14-15 dBm in a 50 ohm system. The impedance and the voltage could be much