开云体育

Tom, This is the software I mentioned in my previous message- looks like he has a handle on it. http://dl2sdr.homepage.t-online.de/ John KC9OJV

A very nice case indeed. Why not give serious consideration to world wide Flat Pack sales of your design ? Ed

I get it now Tom. I thought there already was a USB/Macintosh interface to the Softrocks? I'm fairly sure there was/is. It may have been for DSP Radio. There are a few Windows applications that are in

Sorry for the confusion- here's the original message. Has anyone out there set up a Python routine to capture center freq info from SdrDX and send it out to the Ensemble II? John KC9OJV

Not getting a lot of response, I'll try to expand a little. I am running SdrDX on a MacBook Pro. It listens to the Ensemble RX II nicely. I would like to be able to tune (set the center frequency) of

Very nice. I love it when someone has all the fun tools. I sent you an email from my other account. Mike va3mw

Man, that case is beautiful! Nice work... DE N8XYN Jim Sent: Thursday, January 03, 2013 4:28 PM To: softrock40@... Subject: [softrock40] Re: Ensemble RXTX Project

Congratulations! Hope to hear you on soon and have a RXTX to RXTX QSO! The enclosure is fantastic! 73, Vaughn N2BHA

I have two of the lite II combined kits that I built as starter kits before moving up to the more advanced softrocks. One for 40 meters, one for 20. Both working. I receive many WSPR and JT65 weak

As a follow-on the the 40/30/20 filter discussion and the toroid winding strategy: On my test filter, 16 turns on yellow T37 cores, 220, 470, 220 pF caps, terminated in 47 ohms, measured with a 10X

David Your concerns are valid and there are enough variables here that I think we need more testing and confirmation before ratifying this change. I have put the new filter in place in the 40/30/20

Is it the consensus that this rule applies to all toroidal inductors? Like the 12 that I just built (apparently poorly) for my ensemble rx II? In the 4 BPF circuits? Crap. The thought of going

I did some tests on a 40-30-20 build. Instead of an oscilloscope, which adds probe capacitance (especially on 10X), I measured with a VSWR bridge that uses OpAmps to drive a galvanometer. The

Hi All, I thought that you might like to have a preview of the preformance of the filter thats used as part of the Murphy QRO Mods. I have included the results of the SoftRock 40 30 20 Filter as

Paul, I just found time to have closer look at my Ensemble. The original power measurements I made were with a Watson power / SWR meter at the low end of it's range, so could be a little out. I

Only 3dB attenuation at 20MHz though according to Elsie so probably not good for 30m. If you are prepared to parallel capacitors, I got -0.25dB at 14.3MHz and -15dB at 20MHz by only changing the

Using 220pF/800nH/470pF and 47 ohm load: -3dB at 15.2 MHz -6dB at 16.5 MHz -10dB at 17.9 MHz and FWIW, -1.5dB at 14.3 MHz. Orin.

Actually, the notes had a reference to the Norcal QRP dummy load which had a built-in RF detector circuit. However, the point is valid in that the notes were not clear on the point. I have modified