开云体育

Alex, Some feedback to you for the Creative Soundblaster Live 24 Bit External soundcard and Rocky 1.02. Version 1.02 will start with this card, however, the sound is quite muffled and sound is

Hi Chris, I have now built more than 90 of the v4.0 SoftRock40 receiver. All have worked properly, but some required additional effort. My number one problem was with my SMT soldering. Look very

Can run the PowerSDR test wav files and both PowerSDR and SDRadio can pick the CW audio up OK. But Rocky gives an error message, "Input Device Does Not Support Selected Parameters". Is it possible

Hi, Chuck Many thanks for your "sight": its the first "real" vision I get on Rocky*** Now I just think about having a QSO with a fellow using same SDR and seeing simultaneously each other

I can't answer your question specifically. But, I can tell you that the op amp and the is very quiet, it does not generate much noise. Thus, shorting the antenna where it is soldered to the input

Hi all I am new to the group. I have finished my SoftRock40 today and everything seemed to work fine. But then, after calibrating with an external signal, the noise foor went up to -85dBm and stays

When selecting the start receiver, I get this message. "Unable to start output to SoundMax Digital Audio" Downloaded v1.02 with same results. What am I doing wrong? Thanks. gr GLEN

I hope so.......... Less is always better.

I've just ordered an M-Audio Delta 44 from these people: http://www.nusystems.co.uk/product/M-Audio.Delta.44 ???99.00 including delivery is the cheapest I've been able to find it for. I suppose

Alex, I sent you the WDM file for the Santa Cruz, as you requested, directly. Thanks. 73 Kees K5BCQ ----- Forwarded Message ----- From: windy10605@... To: softrock40@... Date: Sun,

Alex: Now I know why they call these Yahoo groups, YAHOO! Thanks, 73's Bob Alex, VE3NEA wrote:

Hi Alex, I'm still trying to get the Rocky code to run with this Santa Cruz sound card since Rocky requires so much less CPU power when compared to the PowerSDR (which runs fine) and I'd very much

Hi Bob, I have emailed my WDM code to you. Please see if you can make use of it. 73 Alex VE3NEA

You're right!!!!! Thanks for the correction.

Can't seem to get "Rocky" to work with this sound card (Santa Cruz) but boy does it work with the "PowerSDR" software (chunking along at 50-60% CPU). Hats off to you guys involved with bringing this

Alex: It would be a fantastic thing if you shared this technology in some way. I struggled on and off for weeks on end before giving up. I just have too much else to do. I would drop PortAudio

Jean-Claude is right. Let's see: Two lines for input (I/Q IF from radio) , two lines for output (I/Q for audio processing or single channel output). Sounds like full duplex to

Tony, That is what I am running. I was just getting the software setup. I don't have my SoftRock 40 built yet. Have to do some prep for the Sunday School tomorrow morning, so will have to call it

Hi Bill - The documentation for starting out is not all that good for sure. Tuning is done with he mouse wheel (I hope you have one). Unfortunately tapping it changes the step size as well,and tuning

Hi Bill, Be sure to down load v1.4.4 from the FlexRadio site. Version 1.4.5 is there also but Bill has not provided the nessary overlay files at the moment. Hope the little receiver will play well