开云体育

Kenwood TKR-750 Ver2 AUX I/O Programming Help for COR - CTCSS TX Triggering?

VA3EXT All Messages By This Member #169258 Ken, Or anyone that can help. Looked at an old post you commented to. <----Yes, this is very easy to do provided your TKR is a Version 2 1) Program up one of the Aux In/Outs as an output for COS Active Low 2) Program up another Aux In/Out as an input for QT/DQT Enc Enable 3) Jumper whichever pins correlate to the Aux In/Outs you programmed above That's all it should take Ken I followed your instruction & can't seem to get it to trigger the CTCSS tone on COR. Tried on both Channels. Am I missing something? On the KPG-91D software: I have 2 Channels programmed. One with CTCSS Input, & one with CTCSS Input & Output CH 1: RX ,? TX,?? QT/DQT Dec - 123.0,? QT/DQT Enc - None Ch Name - 1 Multi Table - No W/N - Wide Power - Low Ope Mode - Repeat Scan Add - No CW ID - Yes CH 2: RX - XXX.XXXX TX - XXX.XXXX QT/DQT Dec - 123.0,? QT/DQT Enc - 123.0 Ch Name - 2 Multi Table - No W/N - Wide Power - Low Ope Mode - Repeat Scan Add - No CW ID - Yes Aux Port Programming: Edit;? ?Function Port;? On the Aux Select tab:? AUX Input/Output 5 - AUX Output On the AUX tab:? AUX Input:? ? AUX Input Trigger - Level AUX In 3 - QT/DQT Enc Enable AUX Output:? AUX In/Out 5 - COR - Active Low Then jumpered Pin 6 - Pin 24 on DB25 rear of radio. Scott, VA3EXT
VA3EXT All Messages By This Member #169295 I'm trying to get the Repeater to send QT tone only on a COR signal. Then my remote link station will be set to have RX Tone, so the repeater CW ID won't go through the Internet link. Scott
Ken Arck AH6LE All Messages By This Member #169296 If you're using the internal controller. program up Aux In/Out 4 for QT/DT Enc Enable. Program up Aux In/Out 6 as an output and for COR as Active Low. Jumper pins 23 and 25 of the DB25 on the rear together Voila! Ken At 05:40 PM 9/22/2018, you wrote: ? I'm trying to get the Repeater to send QT tone only on a COR signal. Then my remote link station will be set to have RX Tone, so the repeater CW ID won't go through the Internet link. Scott ------------------------------------------------------------------------------ President and CTO - Arcom Communications Makers of repeater controllers and accessories. Authorized Dealers for Kenwood and Telewave and we offer complete repeater packages! AH6LE/R - IRLP Node 3000 "We don't just make 'em. We use 'em!"

Previous Topic Next Topic