If you're using the internal controller. program up Aux In/Out 4 for
QT/DT Enc Enable. Program up Aux In/Out 6 as an output and for COR as
Active Low. Jumper pins 23 and 25 of the DB25 on the rear
together
Voila!
Ken
At 05:40 PM 9/22/2018, you wrote:
?
I'm trying to get the Repeater to send QT tone only on a COR signal.
Then my remote link station will be set to have RX Tone, so the repeater
CW ID won't go through the Internet link.
Scott
------------------------------------------------------------------------------
President and CTO - Arcom Communications
Makers of repeater controllers and accessories.
Authorized Dealers for Kenwood and Telewave and
we offer complete repeater packages!
AH6LE/R - IRLP Node 3000
"We don't just make 'em. We use 'em!"
Ken Arck AH6LE