开云体育

Most, if not all, descibe GE Mastr II. I have a GE Mastr Executive II. What is the difference? And, it is a UHF currently at 451.575. Will it operate within the Ham bands, or is the conversion too

I have found several mods for GE radios to convert them to repeaters. Most, if not all, descibe GE Mastr II. I have a GE Mastr Executive II. What is the difference? And, it is a UHF currently at

Bill Anderson WB9TEW wrote:

w7ntf@... wrote: For those that don't know it, I have recently added a Mitrek conversion site to the RBTIP site. http://www.kuggie.com/rbtip/mitr

Ray Vaughan wrote: There is, but they use Mastr II PAs - heatsink and all... Joe, KR3P

found some Exectutive and from what I here they don't hold up as well as the Master ll radios. Anyone have any coments... This should start an interesting debate. I've found the PA in Mastr (note:

Ditto. Perhaps a post to the list might be in order? It certainly is on-topic. :) Joe, KR3P Marvin Munster wrote:

John, Please, if you would, send me a copy of your notes. I am always looking for improvements on my attempts to convert Mitreks to repeater service. Thanks. Marvin - WB6PKK reduce the shield

I have run into a problem finding G.E. Master ll UHF radios here. I have found some Exectutive and from what I here they don't hold up as well as the Master ll radios. Anyone have any

I've got a Motorola R2009 service monito that's now got display problems. Is there a better choice for repair than direct with Motorola?? (or are there some quick checks that I should do

John, Please include me when you mail your notes, I am always looking for ways to improve my repeater and you may have a new angle I may have overlooked. Bill Anderson WB9TEW John Lloyd wrote:

I have successfully converted two UHF and one VHF mitrek radios to repeater service. 1) check out www.seits.org for info on cenversion 2) the radio's must be aligned propperly BEFORE beginning the

Gary, The Mitreks are easy to modify for repeater service. You will need to reduce the TX Power output since the heatsink is small. You will need to make a shield over the Channel Elements to get

Gary, Try Triton Electronics Inc. in Rolling Meadows IL. They do repairs, alignments and calibration. I purchased the service manual (thick as a phonebook) on a CE6 from them about a year ago for

Tedd, GE also has a version of the Motorola "extender" for Low Band. DB Products makes a Low Band Loop Dipole that can be side mounted on a pole or tower leg. It is a DB-212. They also make a

I use one as a portable/emegency repeater. Conversion was fairly easy. Take a look at http://www.tapr.org/~n3eua/hw/mitrek.html Rick Sherman KM6TI w7ntf@... wrote:

Gary, Check out the repeater pages at the following. www.seits.org Bill w7ntf@... wrote:

Tedd, The Mastr II solid state is a much better radio for repeater use. You could use one of the others, but I would choose the Mastr II. John, K7JL --------------- Tedd Doda wrote:

Hello John, Thanks very much for your assistance. I really appreciate your quick response. It would be great to put my Mitreks into service. They've been gathering dust for quite some time. I'll look