开云体育

I have never had any such failure, what exactly happends? Sure is a 110 watt vers. If I run full power I use fans.

Hi Bob, Yes the ExcII will make a great ham radio repeater. I have not finished working up a written procedure for that unit as I am busy modifying the Master II's. If you can find a book for the

The EEPROM can be programmed in or out of the radio with the TQ-2310 suitcase and cables Andy ------------- NC Certified Firefighter III / Instructor II / EMT-A FCC Licensed Technician / Amateur

Can the eeprom in the Phoenix s or sx be programmed outside of the radio? Ken Whalen vo1st@...

Unless you count the wall mount Mastr Exec II's. Essentially the same hardware as Desk Top but in a nice little wall mounted enclosure. Combo number would start with a "W" as opposed to an

Ray, No, there were no stand up base stations for the exec II. Only the desk top models. John Lloyd, K7JL -------------------- Ray J. Vaughan wrote:

Mark, Since you are in 2 land, I would try Amtronix. Rick Bowman has always been fair and honest with me. Find them at: http://www.amtronix.com Thanks, David Waters, AC4JF Mark Sihlanick

Was there an Exec II base station? I don't mean the desktops, I have a bunch of those. But I don't think I've ever seen a stand up base station. Ray, KD4BBM

Bob, The UHF Exec II will tune to the 440- 450 ham band with no problem. Just put in the ham crystals and tune it up! The Exec II is a little different in how the modules connect together and how it

Most, if not all, descibe GE Mastr II. I have a GE Mastr Executive II. What is the difference? And, it is a UHF currently at 451.575. Will it operate within the Ham bands, or is the conversion too

I have found several mods for GE radios to convert them to repeaters. Most, if not all, descibe GE Mastr II. I have a GE Mastr Executive II. What is the difference? And, it is a UHF currently at

Bill Anderson WB9TEW wrote:

w7ntf@... wrote: For those that don't know it, I have recently added a Mitrek conversion site to the RBTIP site. http://www.kuggie.com/rbtip/mitr

Ray Vaughan wrote: There is, but they use Mastr II PAs - heatsink and all... Joe, KR3P

found some Exectutive and from what I here they don't hold up as well as the Master ll radios. Anyone have any coments... This should start an interesting debate. I've found the PA in Mastr (note:

Ditto. Perhaps a post to the list might be in order? It certainly is on-topic. :) Joe, KR3P Marvin Munster wrote:

John, Please, if you would, send me a copy of your notes. I am always looking for improvements on my attempts to convert Mitreks to repeater service. Thanks. Marvin - WB6PKK reduce the shield

I have run into a problem finding G.E. Master ll UHF radios here. I have found some Exectutive and from what I here they don't hold up as well as the Master ll radios. Anyone have any

I've got a Motorola R2009 service monito that's now got display problems. Is there a better choice for repair than direct with Motorola?? (or are there some quick checks that I should do

John, Please include me when you mail your notes, I am always looking for ways to improve my repeater and you may have a new angle I may have overlooked. Bill Anderson WB9TEW John Lloyd wrote: