开云体育

Do you have any tall buildings around ? Dave Bates [email protected]> wrote:

I've been debating on trying to aquire a site to put a repeater vs here on my vertically challenged tower. In the past I've found contact information & asked tower owners for space. But this was

Hey Jeff, Maybe a step by step on repeater-builder should be written on converting both halves of a DB-420 to (2) DB-408's (with pictures). Sometimes a 408 is just better for the particular situation

Purchase from Yaesu America parts.? I ordered?EH063U90G?but you want to call to make sure part is still current.? I find Yaesu America parts to be very responsive. RichardKD5URB

Does anyone know where to get the service manual for the DR-2X? ?I have tried OEM's site, manuals dk, etc but nothing yet. -- - Regards, Karl Shoemaker Please remember not to reply (email) from this

Now that I think about it, and assuming my memory and visualization of the DB420 harness isn't failing me, if you cut that half-antenna feeder cable off as I described, then took the harness off and

In my testing the load was indeed going to be taking half the power. After all that is what the harness is supposed to do, divide power for both 8-bay halves to work properly. The purpose of using a

? Looking at an old DB420 here there is a molded triangular shaped splitter junction on the bottom section that heads off to the top section. At that mid-point splice, the pointy part of the

Looking at an old DB420 here there is a molded triangular shaped splitter junction on the bottom section that heads off to the top section. If you terminate the coax that went to the top section with

Joe, It is the bottom half of the antenna less mast, so yeah it has the harness and a female "N" connector for the top half to connect to. It includes the bottom half loops and clamps with stainless

I distinctly remember there was some difference between the two repeaters as to pinout. Like I said though, maybe they were close enough that it doesn't matter for ham applications. Oh well...

This is not correct. Both the TKR 850 and NXR 1800 (and 1700 for that matter) have the exact same pinout for both RX & TX audio (RA/RD/TA/TD), as well as externa PTT in. COR & TOR are programmable as

First, the two controllers have different pinouts from each other. Next, the TKR 850 and the NXR 1800 use different pinouts from each other as well, although they are close, maybe close enough. But in

Cool thanks Ken Sent: Wednesday, May 28, 2025 4:33 PM To: [email protected] Subject: Re: [repeater-builder] Scom 7330 repeater controller software Yes

Yes

Thanks Dave. I appreciate all the information. I'll take a look at it. And do you know or does anyone know if the Arcom RC 210 uses the same pin programming for the back of the Kenwood TKR 850 and NXR

Is it the bottom half that has the splitter and jumper to the top section? If so how do you deal with that when using the bottom as a stand alone antenna?

I may be interested but I am not sure what you are sending? The top half or the bottom half of the 420, and with the mast or just the harness and loops? Please let me know. Joe [email protected]>

You have it wrong. 1. Drop your Baofeng in a septic tank. 2. Never look back. 3. Forget all the other things listed here. Mick - W7CAT

Hi Chad, This cable is available from a reputable vendor on eBay: https://www.ebay.com/itm/122562581175 I have used his cables on previous projects.? They all work well. You can program the