开云体育

well, i dont have much choice on my Rav4 2009, on the rear i have a fiberglass spoiler,,i dont want an hole. i am stock with the glass mount on the side ,a compromise situation. gervais

hello tedd, yes i add one of these long time ago ? , there is a little screew to adjust the SWR at the low point. i just found one here in my scrap yard ? ,,an old Larsen that i have no idea the

Hi Gervais, I have 2 of these from years ago. They are very old stock, but are complete. They are marked 144-148 and 440-450. They have an adjustment on the internal box. There are no other marks on

If it is this type of Superflex, it might be fine. https://www.solidsignal.com/rfs-1-2-inch-50-ohm-superflex-coax-cable-15225330 But most of us refer to Superflex as something that is more like

You really should consider Heliax over Superflex. All the Best & 7 3s Dale Miller, KC2CBD Cookeville, Tennessee Putnam County TN ARES Emergency Coordinator Vice President Cookeville Repeater

That may be so Milton but I've had half inch superflex running to my HF and VHF antennas for over 4 years without any issues.. if it can stand the Texas heat it can stand anything LOL Chris WB5ITT

Consider a trunk lip mount. I have used these on hoods and trunks as well as some other locations. Milt N3LTQ

Superflex is not intended to be used for exterior antenna runs. It was developed for interior cabling in shelters and racks where tighter bends were needed. Use regular Heliax for exterior runs. Milt

Roger and Gervais, I used a Larsen glass mount on my wife's 2001 Cadillac STS, until we had to replace the rear glass... Like Roger noted, the new glass must have been of a different "mix", as I could

yes roger,i think i have a special place on the side windows for that ,,it is molded in the glass or it was on the rear windo,, i will check thanks Gef ________________________________ De :

ahh way over my "retired man " budget andy, 250$ here at Radioworld.ca. des voleurs,,,, way to much for me gervais ________________________________ De : [email protected]

Hi Dale, Building say a 4 bay UHf array is not going to be as easy as purchasing one, (say DB products) used, and remaking the harness for your frequency, as was already stated. It may not be cheap

I May be interested but can we see specs on this device? [email protected]> wrote:

picture ? or make and model ? [email protected]> wrote: -- John Kreno The line separating good and evil passes not through states, nor between classes, nor between political parties

I recently sold five of these and found I still have a bunch more of these little machines. I have one myself I use with freeDoS on a USB thumb drive with all the DOS based RSS, GE, etc and it just

Use caution with glass mounts. Some vehicles have a high metal content in the window tint that seriously degrades performance. Roger

If you can't find a DB408 / DB420, a similar one to the 712EFC would be the Comet GP-6 which will have a tiny bit less gain, but none of the desense issues. But the 408 or 420 will still beat it as

I don't often use a glass mount antenna ... but when I do, I use the Larsen Dual band glass mount. Like this one: Larsen Dualband Glass Mount Antenna 2m/70cm - KG2-70CXPL Andy [email protected]>

At 5/7/2025 07:27 AM, you wrote: It makes a great base antenna.? ? But yeah, I have one too I would let go for $50 that's brand new. (as in never installed outside).? ? I made the same mistake,

At 5/7/2025 07:03 AM, you wrote: I will see if I can find something else at Dayton for the GMRS antenna. I purchased the CA-712EFC based on recommendations of people using it in repeater service. We