开云体育

hi everyone, first Best 2025 to all of you ! and i appreciate a lot the tolerance of the Moderator when i arrived with some questions that are not full repeater subjet! i dont remember but on the

Greetings to the Group, Looking for a working Motorola UHF R2 (438-470 MHz.) 100 watt RF power amp. Thanks, Randy K9MMQ

There is a ham in So Cal that has been banned from several repeaters and from what I hear in most cases the repeater owner/trustees sent him a letter and may have copied the local FCC office. In one

At 1/4/2025 12:12 PM, you wrote: I built and maintained multiple repeaters on multiple bands, on multiple mode for me or for club/organisation.? In no time I feel that I can prevent anyone from

Chriss, encryption is illegal in Canada, unless the key is available for everyone to enter into your radio and be able to listen to the stream. Thank you for the clarification.

Chriss, encryption is illegal in Canada, unless the key is available for everyone to enter into your radio and be able to listen to the stream. This have been reported to me as being what ISDE said to

I built and maintained multiple repeaters on multiple bands, on multiple mode for me or for club/organisation. In no time I feel that I can prevent anyone from using a repeater but if it is being

Speaking of closed systems, some hams in Hamilton Ontario Canada (allegedly) have an encrypted DMR machine. Is that legal in Canada? I know encrypted transmissions are illegal on the amateur

Hi all To me running a closed repeater system goes totally against the ethos of Amateur radio. I'm also in Australia and all repeater systems must be open to any licensed ham to use which is the right

Looking to sell my Hewlett-Packard 8590A option 001 $600 plus shipping

900 MHz is where we did the most experimentation with hearclear. One local repeater runs it, another does not. We tested on Mike k8mdm's 900 quantar with and without it as well. We normally don't

Regarding replacement fans. Any recommendations on known compatible fans? -Doug- yahoo.com@groups.io> wrote:

First make sure you the orientation of your replacement 28HC64 is correct in the socket. Then make sure the SCM is pushed all the way in to the card sockets. They can be a real pain to get seated

Ok so update. And it does not seem good. got the replacement parts from digi key today. had previously cleaned the board good and it’s been sitting out the IC chip and the machine had all lights red

If I was designing a system for preventive maintainance, I would monitor the current both start up and run. As the friction increases (bearings wearing) the current would rise.? This is how I'd do

Doug, Is it possible that it's not spinning at full speed? Burt, K6OQK

If I recall correctly Motorola’s HearClear system was only available on 900MHz and maybe 800 MHz radios. It was not available on VHF & UHF.

Well time for me to throw to half Pennie’s into the mess. And I fall directly into this question. I put my own DMR system because dmr around me sucks and the coverage is worth crap. those hotspot

Hi to All, For part to finish a project I am looking for a Tait T500 VHF Mobile. I know this radio was not to good even new with plastic cover and is very out of date but hoping someone has

In the case of the processing on W6MEP, the pre-emphasis is part of the ORBAN 8100A processor and the two work together to maintain deviation.? The processing consists of both gated AGC and a peak