开云体育

I bought one off ebay to program a Kenwood and it installed just on 2 different computers that has Win 10 on them.? No problem installing them and loading the program and programming the

Did you get a counterfeit?? Or is this on win xp? Sometimes you can get this to work on Windows 10 but other than that the old radio software will not work on Windows 10 and definitely will not

Ordered one of these cables to get the Mtr to read and after spending 3 hours of my life I will never get back cable refused to install. anyone else have this issue where no matter what you do as an

I likewise use AREDN for all my links between repeater sites. No monthly fees and the hardware can be quite inexpensive when purchased off

We load AREDN code into them and get 4 additional channels above the Pt 15 band and it is all amateur radio based. Here is the AREDN Web Site: https://www.arednmesh.org/ That is for the jackwipes that

mine is maybe 2660s or other models have a higher resolution I tried to talk my monitor into syncing at a higher res to no avail

<— Must be AI ;) - how many times have you heard that this week? ;)

<—- Hi Jared, as Wayne said, I just plugged my cable in, turned the monitor on and there she was. I didn’t change any settings.

I have encountered some of these older Windows RSS will only function properly on 32 bit iron (CPU), and not 32 bit Windows (or in a 32 bit VM) that is installed on 64 bit architecture. tnx Mike /

sure looks cleaner at the higher res although it is resolution from thin air

How did you get yours running at 1440x480? Mine runs at 720x240.

Sorry, just realized you stated in the OP that it was 32 bit Windows XP...? If it were me I would start troubleshooting with different cables, different radios, different? RSS/CPS to confirm the

Your problem isn't the speed of your computer, not with MTR2000 RSS; the crucial thing is it has to be the 32 bit version of windows for the communications to talk to the radio. Same thing for

Am looking for the 25-pin DSUB alignment cable that goes with Vertex FIF-12 programmer and CT-49 alignment software. Have the FIF-12 interface and frequency programming interface, but not this cable.

I have a TKR-850-1 that was working fine but now powers up with an E2 error code channel data not written. Can read radio and all data is read and good. Tried rewriting data with negative

<-- Hi Andy... doh, thanks for checking and pointing out a "drawing error".? I have updated the drawing post haste! Good catch! Ramesh, VA3UV, WA3UV

Hey Ramesh, Was the shield supposed to be hooked to ground instead of red? Andy wrote:

Ramesh Dhami &#92;(VA3UV&#92;) <Ramesh@...> added folder */Motorola 2600 Series Communications Test Set* --- The following items have been added to the Files area of the

Thanks Sent: Tuesday, March 18, 2025 9:36 AM To: [email protected] Subject: Re: [repeater-builder] Kenwood TK 8360 question Hi Chad, I have an 8360 that I use as a UHF base station

Hi have a 8180 and the audio doesn’t sound as good as the 8302. That is my main complaint I suppose. Sent: Tuesday, March 18, 2025 9:43 AM To: [email protected] Subject: Re: