开云体育

if you have line of site then a pair of these little cheap beauties will give buckets of bandwidth https://uk.store.ui.com/uk/en/category/all-wireless/products/litebeam-5ac we have wifi links from as

Adrian, If you have line of site or you can make a LOS shot a pair of Ubquiti 5GHz radios configured as an Ethernet bridge.? 500m should no problem.? I suggest 5GHz if it is available in your

Mike/Jeff OK. So the cable you want to put a connector on is ANULAR, as opposed to SPIRAL, is that correct? If so, I will change the 7/8" NF cutoff connector I was planning to send. BTW The Spiral

Anthony; I have done it with Hamvoip.? We are in the process of converting to ASL3, but I have not gotten this to work with that distro yet.

Good morning everyone and happy Saint Patty's day! Does anyone have a used fairly inexpensive UHF repeater that I can purchase for a back up system? Chad Nelson WI9HF/WRPL979 Janesville

Jeff, You are correct and I did not note that in Charle's offer/comments. It is not a spiral type cable. BTW Jeff..I'd still like to have some direct communication with you if at all possible. My

Use an external Yagi for the wifi...they work great ...use them all the time with BDAs...500mtrs should not be a problem with them...does your wifi router have external antenna connectors? Chris

Just to make sure we/you/all are on the same page, Mike’s cable is not helical (spiral) corrugation so it wouldn’t be Phelps-Dodge (FXCC series). --- Jeff WN3A From:

Do you have line of sight to the repeater? Matt AL0R Sent: Monday, March 17, 2025 07:50 To: [email protected] Subject: [repeater-builder] Internet provision at a remote repeater

Mike OK. I'll send you one. Regards, Charles F. Adams K3HKZ Industrial Communications Co. 121 N Sitgreaves Street Easton, PA 18042 Office 610-253-1214 Cell 610-360-0050 Fax 610-253-4504 Sent:

Charles, The address here is: * Miike Ryan * 4828 Commonwealth Road * Palmetto, FL 34221. Thank you very much! - Mike Sent: Monday, March 17, 2025 8:55 AM To:

Hi The 7/8" cable you have is probably Phelps Dodge with solid center and spiral outside. No soldering required. We have a few used (cut off) connectors laying around, which I would offer FREE if you

I am the keeper of GB3VS a UHF repeater in the UK .it operates using the ARCOM 210 controller ..which has 2 spare channels I am considering connecting it into the Allstar network but the site has no

As you are no doubt finding out, the average ham radio has 25kHz IF filtering and +/- 5kHz (or more) TX deviation with little or no modulation limiting. Your choices for equipment that can resolve

These units are sold, thanks for all the interest.

Can I make a suggestion?? Of course, I don't know your specific situation but our experience is that jerkoffs who do that crave negative attention and would actually jam just to get us to turn the

The Motrola CDM series will also narrowband and are great mobile radios The CDM 1250 and CDM 1550 (my favorite) Lloyd KO4L [email protected]> wrote:

Almost any Kenwood with the model TK-7xxx will do those splits. The Kenwood repeaters TKR-750 and 751 will also do those splits. Roger, N5QS

Hello Tim, For mobile radios, the M1225 and CM300 will both work for narrow band. I would be very sure the P1225 and CP300 portables will also. Mick - W7CAT

I meant to say Part 90 services..... -- The Real RFI-EMI-GUY