开云体育

Ok so this is the setup. IBM Lenovo laptop 697 MHz with 0.97 megs of ram 1 gig basically. running windows xp 32 bit no true com port but two usb available. Installed all the different persons of the

I programmed a MTR-2000 with my laptop running 32 bit Windows 7 and a USB --> RS-232 adapter. Mick - W7CAT

The band pass is tuned by the shaft. The capacitor tunes the notch only.. I use a spectrum analyzer and service monitor to tune my Wacoms, DBs, TXRX, etc..Kit Parsons at Wacom suggested a signal

Gentlemen, What is the "Proper" way to tune a 443mhz bpbr Wacom ? S11 with a 50 ohm load at the antenna port? or S21? ? I can "see"? ( and tune ) the notch on S11 , but the notch is

MTR CPS does not run on anything above win XP Chris WB5ITT [email protected]> wrote:

Excuse me?? To talk to the MTR takes a RJ45 cable to DB9 adapter.. I wired one up myself in 5 minutes that works. I've never had a problem with Blue Max 49 as far as his cables are concerned. The MTR

Part number of cable?? ? RS-232(DB-9 or DB-25 on PC?) to radio adapter (native RS-232 port on PC) or using a USB-to-radio adapter cable? Another way of asking that - does the (un-named make/model)

I bought 2 for a HT1250 and a XTS3000. Both work great on Win 7 32 bit. Make sure you install the FTDI driver. Cecil

I bought one off ebay to program a Kenwood and it installed just on 2 different computers that has Win 10 on them.? No problem installing them and loading the program and programming the

Did you get a counterfeit?? Or is this on win xp? Sometimes you can get this to work on Windows 10 but other than that the old radio software will not work on Windows 10 and definitely will not

Ordered one of these cables to get the Mtr to read and after spending 3 hours of my life I will never get back cable refused to install. anyone else have this issue where no matter what you do as an

I likewise use AREDN for all my links between repeater sites. No monthly fees and the hardware can be quite inexpensive when purchased off

We load AREDN code into them and get 4 additional channels above the Pt 15 band and it is all amateur radio based. Here is the AREDN Web Site: https://www.arednmesh.org/ That is for the jackwipes that

mine is maybe 2660s or other models have a higher resolution I tried to talk my monitor into syncing at a higher res to no avail

<— Must be AI ;) - how many times have you heard that this week? ;)

<—- Hi Jared, as Wayne said, I just plugged my cable in, turned the monitor on and there she was. I didn’t change any settings.

I have encountered some of these older Windows RSS will only function properly on 32 bit iron (CPU), and not 32 bit Windows (or in a 32 bit VM) that is installed on 64 bit architecture. tnx Mike /

sure looks cleaner at the higher res although it is resolution from thin air

How did you get yours running at 1440x480? Mine runs at 720x240.

Sorry, just realized you stated in the OP that it was 32 bit Windows XP...? If it were me I would start troubleshooting with different cables, different radios, different? RSS/CPS to confirm the