开云体育

I just went through our repeater here in Mount Vernon, Ohio.??? A communications company call Vasu communications here in Ohio makes a very nice power distribution panel I got one for about 175.00

Mods are still required to use a GE voter without status tone if you want to do it right. For starters, you'll want to get rid of the 1950 notch filters on the receiver cards and the audio module to

The Motorola sites engineer came up with the solution using only a BP duplexer on each repeater along with a dual stage isolator. A 3rd duplexer was not needed. Jim W7RY -- Thanks and 73, Jim W7RY

[email protected]> wrote: Thank you. >

Yes, Mr. Donovan, that's a scenario that happens after the grid power is restored; the "charger" try's bring the station battery back up. The solution is to either beef up the breaker and supply or

Nearly all of the VHF Sensicon "A" Receivers I ran across back in the 1970's were the ones that had five pipes in the front end. We did have one Receiver in a base station at our college that had six

I have a couple of the Motorola factory MT-300 Repeaters. I have one of them that I was able to get the correct low-VHF split modules for, from an MX-340 hand-held radio, replacing the high-VHF split

And it's power supply !!? What is this world coming to???? Being wideband, and I mean very, it was just collecting dust in the leanto. But yea that's how I got started. on .81. You remember our

With the modifications they should. -- - Regards, Karl Shoemaker To contact me, please visit SRG's web site at http://www.srgclub.org for the current email address.

Just so every knows it doesn't work on narrow band, At least according to the manual.

This is a newly designed product? Could've fooled me, as I don't see a single surface mount component. Even when hand soldering I consider surface mount easier to work with than thru-hole. Bob NO6B

The is a diagram using motorola T1500 duplexers for this exact case, and you can try searching for it. Basically it takes 3 sets of 1500's each repeater has a duplexer that is then fed into a third

The big unknown in your case for how big a battery is how long does it take for you to respond if a total power fail occurs. You have to figure the powerloss as time zero, add noticing loss if not

Details!? ?Where is it available?? How much?? ?What does it do that the thin client doesn't?? ?? Vendor website info would be handy.?? ThanksChuck? ?n0nhj

Everybody keeps talking about mods to the GE voter. E&M signalling is standard on them, even the old grey ones. So voter tone isn't needed if you have a relay closure or other good switching.

Our repeaters are all under a single radio club and everyone is a team player, so I don't anticipate any political issues.? I was nervous about sharing a single power system among multiple repeaters,

You may need to look at a board house that will stuff the majority of the parts on the board. Depending on qty of boards that may help price point. Stan

I have to sit down and figure out the per unit price, but I probably won't be able to compete with the price point once labor is factored in.

All, Upon further review, I overreacted to this situation. I had a awful day full of stress and I publicly apologize to Terry for my overreaction. Scott -- Scott Zimmerman Amateur Radio Call N3XCC 474

All, As group owner - I asked Terry to send me the photos - which he did immediately.? After reviewing them - I don't feel that Terry did anything wrong - - and I don't feel he misrepresent the sale.