开云体育

Thanks for the reply's on the Master ll vs Mastr Exec ll... This has brought up another question... Will the mobile radio work the same as the desktop? Most of the reply's I have read are dealing

I am on a fact finding mission, gathering information about the pros and cons of a particular antenna design/configuration. This antenna will be used on a VHF repeater (Monteagle, TN.) We need near

I have never had any such failure, what exactly happends? Sure is a 110 watt vers. If I run full power I use fans.

Hi Bob, Yes the ExcII will make a great ham radio repeater. I have not finished working up a written procedure for that unit as I am busy modifying the Master II's. If you can find a book for the

The EEPROM can be programmed in or out of the radio with the TQ-2310 suitcase and cables Andy ------------- NC Certified Firefighter III / Instructor II / EMT-A FCC Licensed Technician / Amateur

Can the eeprom in the Phoenix s or sx be programmed outside of the radio? Ken Whalen vo1st@...

Unless you count the wall mount Mastr Exec II's. Essentially the same hardware as Desk Top but in a nice little wall mounted enclosure. Combo number would start with a "W" as opposed to an

Ray, No, there were no stand up base stations for the exec II. Only the desk top models. John Lloyd, K7JL -------------------- Ray J. Vaughan wrote:

Mark, Since you are in 2 land, I would try Amtronix. Rick Bowman has always been fair and honest with me. Find them at: http://www.amtronix.com Thanks, David Waters, AC4JF Mark Sihlanick

Was there an Exec II base station? I don't mean the desktops, I have a bunch of those. But I don't think I've ever seen a stand up base station. Ray, KD4BBM

Bob, The UHF Exec II will tune to the 440- 450 ham band with no problem. Just put in the ham crystals and tune it up! The Exec II is a little different in how the modules connect together and how it

Most, if not all, descibe GE Mastr II. I have a GE Mastr Executive II. What is the difference? And, it is a UHF currently at 451.575. Will it operate within the Ham bands, or is the conversion too

I have found several mods for GE radios to convert them to repeaters. Most, if not all, descibe GE Mastr II. I have a GE Mastr Executive II. What is the difference? And, it is a UHF currently at

Bill Anderson WB9TEW wrote:

w7ntf@... wrote: For those that don't know it, I have recently added a Mitrek conversion site to the RBTIP site. http://www.kuggie.com/rbtip/mitr

Ray Vaughan wrote: There is, but they use Mastr II PAs - heatsink and all... Joe, KR3P

found some Exectutive and from what I here they don't hold up as well as the Master ll radios. Anyone have any coments... This should start an interesting debate. I've found the PA in Mastr (note:

Ditto. Perhaps a post to the list might be in order? It certainly is on-topic. :) Joe, KR3P Marvin Munster wrote:

John, Please, if you would, send me a copy of your notes. I am always looking for improvements on my attempts to convert Mitreks to repeater service. Thanks. Marvin - WB6PKK reduce the shield

I have run into a problem finding G.E. Master ll UHF radios here. I have found some Exectutive and from what I here they don't hold up as well as the Master ll radios. Anyone have any