开云体育

I've got a Motorola R2009 service monito that's now got display problems. Is there a better choice for repair than direct with Motorola?? (or are there some quick checks that I should do

John, Please include me when you mail your notes, I am always looking for ways to improve my repeater and you may have a new angle I may have overlooked. Bill Anderson WB9TEW John Lloyd wrote:

I have successfully converted two UHF and one VHF mitrek radios to repeater service. 1) check out www.seits.org for info on cenversion 2) the radio's must be aligned propperly BEFORE beginning the

Gary, The Mitreks are easy to modify for repeater service. You will need to reduce the TX Power output since the heatsink is small. You will need to make a shield over the Channel Elements to get

Gary, Try Triton Electronics Inc. in Rolling Meadows IL. They do repairs, alignments and calibration. I purchased the service manual (thick as a phonebook) on a CE6 from them about a year ago for

Tedd, GE also has a version of the Motorola "extender" for Low Band. DB Products makes a Low Band Loop Dipole that can be side mounted on a pole or tower leg. It is a DB-212. They also make a

I use one as a portable/emegency repeater. Conversion was fairly easy. Take a look at http://www.tapr.org/~n3eua/hw/mitrek.html Rick Sherman KM6TI w7ntf@... wrote:

Gary, Check out the repeater pages at the following. www.seits.org Bill w7ntf@... wrote:

Tedd, The Mastr II solid state is a much better radio for repeater use. You could use one of the others, but I would choose the Mastr II. John, K7JL --------------- Tedd Doda wrote:

Hello John, Thanks very much for your assistance. I really appreciate your quick response. It would be great to put my Mitreks into service. They've been gathering dust for quite some time. I'll look

Hi Bob, Thanks very much for your assistance. I'll check them out. 73, Gary, W7NTF

Hi John: How do I find out? I used the Mitrek on 52.525 with a bunch of computers in the area, and found it to be quite quiet. My Alinco DR-M06 is horrible at noise rejection on the other hand. Both

Greetings, I have a Cushman CE6A service monitor which would prove extremely helpful in my repeater projects. Unfortunately, my service monitor is in need of repair. Additionally, I do not have any

Greetings, This is Gary, W7N TF, in Spanaway, WA. I have two UHF Motorola Mitrek mobiles that I was going to convert to repeater service before I got ahold of my GE Mastr-II mobiles. I may still go

Actually, at 6M receiver sensitivity is not an issue unless there's been a lightning strike - the real thing to look for is, which if either unit has an RF noise blanker? The Motorola "Extender" is a

David Armstrong KF4LJR Technical Advisor, Southeastern, Division 440 Plunkett Dr. Horton, Al 35980 205-593-5321 home of the 443.725 Repeator an 53.030 How much an does it work, for the uhf master

That's the kind of information I was after. I thought having tube outputs would make it tougher? Only the old Master (1?) base unit has tubes, the Master II (mobile) is solid state. Any comment on RX

Thanks Ed. The sites address is: http://www.nhrc.net/mastr2/index.html Great stuff, and it looks very easy to do the mod's. The Master II is tuned up on 52.525, so it shouldn't take much to get it

To be exact: http://www.nhrc.net/ The Mastr II link is at the bottom. Ray J. Vaughan, MS, CBTE KD4BBM ray@... http://www.rayvaughan.com/