开云体育

I share your pain. Not a clamp meter but taking reading in a very obstructed unit I had the analogue meter laying on it's side. I spent ages trying to adjust the unit to the specified settings. Other

For getting into confined spaces I find a clamp current transformer works better for me, what i have is a unit about 1x1.5x3" which outputs on a pair of 4mm sockets. 200A:200mA, the DMM can then be in

I have the 6 cavity version and it works just fine at 130 Watts ------------------------------------------------------------------------------ President and CTO - Arcom Controllers Makers of repeater

I only did a quick look at that one.? I am not familiar with the brand.? I did not see a CAT rating for it.? For home use and maybe up to the 240 volt line the China ones are probably ok.? I have

I had a set just like those a long time ago. It was a Q202-G. Bob NO6B

When looking at clamp meters, please don't make the mistake I did. Some don't have balanced meter movements. The first one I bought is great when the clamp and meter are horizontal. When vertical, the

We had purchased a mini clamp meter for use at the place I used to work for. It was similar to the one on Amazon "Extech 380950 Mini AC/DC 80A Clamp Meter" but I don't remember the brand. We found

Pair? Looks like an old Q202G. Issues that I would be concerned about: I don't remember ever seeing hose clamps on the tuning assembly on any Sinclair cavities - there was always a setscrew. I have to

Thanks, Dave for your input. Yea, for anything real serious I got back to my old favorite since the 70's and that's Fluke ! -- Regards, Karl Shoemaker To contact me, please visit SRG's web site at

I have only see those trombone notch tubes on Old WACO's from the 1960's... My recommendations... I recalled a "duplexer repair guy" in Alabama 8-10 years ago.. I googled this.. It may help:

I wonder what would happen if you programmed the ID timer to zero, or if it is even possible to do that.? I don't see a range listing of valid values in the manual. Joe

Hi Rodney, The NHRC4 -M2 Operating Manual describes most things in a bit more detail. ?I am hopeful you are looking at the document. ?While there doesn’t seem to be a command to shut off the

Fair enough.? Like I initially said, I was just curious. Thanks. 73 de Mark - N9WYS? Please excuse all typos... Fat fingers and hyperactive spell check at work! On Wed, Jan 13, 2021 at 20:24, Jay

Karl, ...Been following your postings. The purchase price (AND compactness) of “True RMS” clamp meters has come down considerably over last 50 years. Meters similar to what you purchased (prices

That's correct, Joe. Same formulas & general parameters. -W6XC

Sorry Rodney, I was looking at my NHRC-3 M2 manual -- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus

I have some old GE MASTRII training documents and thought that it had the information contained in it, but no. I think the MASTRII and MVP shared the same crystals, just the oscillator holders were

Have you tried setting the first character of the ID to FF (end of id) Gerald WD0FYF -- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus

Hi folks, I recently purchased this meter off of Amazon and it appears to be a good one for $50 OTD.? Well at least, as long as China stuff does.? I've made my measurements in load center and I'm

I'm selling because 33cm in the metroplex is a mess. to much part 95 QRM.