开云体育

There is a flavor of DMR trunking that has a control channel - Motorola Connect Plus which uses a 3600 control channel that sounds very similar to a legacy SmartNet or SmartZone 3600 control channel

Those foreign power supplies are a nightmare, and hardly worth it unless it's only a fuse or something simple. You can always run it on 24-28vdc and it'll probably last longer. I've put a number of

You are close. There is a DTMF command that will activate the RS-232 connection: "Remote Activation Of The RS-232 Port To activate the RS-232 port, key-up and enter the control operator prefix

So all the D-STAR, DMR, PL decode FM, and similar have mic hook switches to monitor the frequency before transmit??? (I think not). Just as an example: DMR transmits to get an admit tone long before

This may not work on the CAT1000. I believe that you need to turn the CT1000 off, operate DIP switch 8, then turn the CAT1000 back on the activate the RS232 connection. Joe

The most common failure to these supplies was simply two fuses and two varistors (the two blue discs right near the two fuses). It's pretty much a MUST to have some sort of AC surge protecting device

Have you tried doing a packet RF link to the controller? Just a thought if the site is far away. -- Regards, Karl Shoemaker To contact me, please visit SRG's web site at http://www.srgclub.org for the

Mike, Hey ...it's really good to see you back on here posting again. I have one of these power supplies that I starting digging into also. It's been a while since we talked on the phone but if you

You could put a block converter in front of the VHF receiver. Many years ago I heard of a voting system that used a number of VHF to UHF crossband repeaters as satellite receive sites. They all

I have two 100w UHF MTR2000s that are perfectly good but the AC side of the power supplies are dead.... they work fine with a 24 or 28v DC supply of adequate current... But I'd like to get the AC

If you have VOIP then you have IP available. Ignore the modem. Just like trying to use a fax machine on VOIP it will always be flaky. Put a Terminal Server on the RS232 port.?? I use the Lantronix

Hi, There are many parameters which have affect to the transmitted FM audio level. My procedure to set the primary level is this: 1. TxLevel is set to 84 in the configuration file 2. With the

In regard to the Case #2 argument, I agree with Joe.? If a user IDs at the end of 10 minutes, it doesn't matter to the FCC if it gets repeated or not - YOU are ID-ing for YOUR station on the

Disregard: PTT buffer issue. Bob NO6B

I'm trying to modulate a Kenwood TK-880 via the DI input. Have done this on half a dozen radios, but the one currently on my bench won't modulate. MIC input works fine, but I need the DI input. The

I am using RFAudioBoost = 3 on my 2 repeaters. I adjust TX as follow With MMDVMCAl set for DMR. I adjust software level to 50 and adjust TX pot for carrier null. Put DMRTxLevel to 43 in MMDVM.ini With

Thank you, This is the config that I have been

Good day, I recently updated my Pi-Star and STM32-DVM to the latest and greatest. I see and hear a LOT about the FM Mode that has been integrated, but NOTHING on the configuration and actual running

Brett, I was looking for exactly that text but couldn't remember where I found it! I searched my mailing list archives thinking it was more recent. I wonder if we can get that section promoted to

That’s why you speak your call into your microphone