The document I have states the operating freq's are 52.87/53.87
Should be close enough to work anywhere in the 52/53 range.
I'm running 200 watts into the thing (50 w over the cont. power
rating) with no desense. I'm using a Motorola Micor 330w station.
What are you using for for RF gear?
Chris
N9LLO
Tedd Doda wrote:
toggle quoted message
Show quoted text
tried it the first time you sent it to me and it didn't
make much difference, but I tried it again yesterday, making
all new cables, and it help alot. I think the first time I
included the connector length, but noticed the second time
that the length was "cut" length!
The SWR going into the TX port is now a respectable 1.7 to 1,
from a 3 to 1 (still a little high), but the SWR going into
the RX port went from 2.9 to 1 down to 1.2 to one. This is
using an MFJ 259 with a cellwave 50 ohm dummy load (ex cellular
circulator stuff).
When you got the dimensions from Db, did you specify a TX
and RX pair? I'm hoping that something is just slightly off
as the desense is still very obvious with only a 30 watt
drive (into a dummy load, doesn't make much difference going
into a home-brew "J" pole so the antenna must be ok).
