Has anyone had the plungers in the DB4060/4062 replated with silver before? I have a set that needs new plating and am in the process of getting a quote with a local company to get them done. If it's not too bad, I will probably do it. However, I'm unsure of the thickness of the plating. I'm thinking too little will cause the contacting fingers to dig through the plating into the brass, but too thick would make the surface too soft because of thick silver deposit and cause problems too. I was able to measure a piece that flaked off with a micrometer at half a thousandth of an inch.?
?
I'm also at the point where I don't want to invest anymore into these cans and just put the money towards a new set. What to do lol.?
?
Joe
