¿ªÔÆÌåÓý

Re: Isolated Tee


 

My iso tee / RF sampler arrived today.?
?
Is this a good way to measure & set the attenuation? I put the sampler on my KC901J. Then put a 50 ohm load on the bnc sample side. Then fully 2 port calibrated the cable & tee connector with my keysight calibration set.
?
?After that I moved the narda 50 ohm load to the other direct RF port of the tee. Then hooked port two onto the bnc sample side. Then adjusted the slide to vary & set the attenuation to 50db just for now.?
?

Join [email protected] to automatically receive all group messages.