Why not just take its mates down to the Bolt shop,
while there buy a set metric thread gauges,
they may even have a A4 card with all the metric threads listed, for free?
Just thinking outside the square ..
John VK4JKL
toggle quoted message
Show quoted text
On 20/04/2025 10:44 am, Jeff DePolo WN3A via groups.io wrote:
I checked the loops on my 4062 cavities to verify the range of the duplexer.
The HIGH pass cavities used loop "005", LOW pass used loop "004"
Am I correct to assume this duplexer is a "B" range?
Yep, you're good with those loops.
I'm pretty sure the screws are #6-32 x 1/4", stainless. I can measure one if you can't verify.
--- Jeff WN3A
