About 3 years back I had one DB4332-B UHF low pass filer but needed two, so decided to reverse engineer it and build a clone. The variable piston capacitors are Johanson 0.8 - 10Pf rated at 150V. Back then I found several sellers on ebay offering them, and there was one selling them in 4 packs for $25 plus some shipping. The trimmer cap model I used was PC25J100. The model is stamped onto the top solder side of the cap, so usually not possible to see in the original LPF. Just checked on ebay but original listing is gone, however looks like listing #256220267439 is the same guy still offering those trimmer caps in packs of 4 still at the same price.
The 3 coils are made of #18 wire, one side being 2T, the middle one 3.5T and the last one again 2T. Coil diameter is 7/32 or about 5.55m, stretched out same as the original coils.
I also managed to find on ebay someone selling the identical metal boxes (Pomona model 2413) for $10-15 new old stock in the original bag and with connectors on each end, but these instead had one SO-239 and one PL259, which both where very easy to replace with NM/NF. I then also had to drill the four holes to mount the trimmer caps and assemble everything. The clone LPF was then checked on a VNA and compared to the original DB4332 and it had basically identical characteristics as the original one, and of course also tuned up just fine.
About a year later after that I needed two additional UHF LPFs and did build two additional clones that also worked perfectly. The attached picture shows the original LPF at the top, and one of my clones in the blue box at the bottom.
