Greg:
?
? ? ?OK, here it is. The PDF schematic is attached and is very specific to my build and includes lead lengths in inches. The TX LED is not fully implemented because the polarity and levels do not match. I use the ignition sense to power up the radios, otherwise the radios will not power up after a power cycle.
?
? ? ?If you use the purchased cables you do have to figure out the pin mapping. I made my own cables because I wanted special wire and custom lengths.
?
Larry
?
####################################################
Motorola CPS for FM repeater
####################################################
?
common
? ? Radio configuration
? ? ? ? Lights/LED's
? ? ? ? ? ? Mobile Backlight Intensity High
? ? ? ? ? ??
? ? ? ? Tx Power
? ? ? ? ? ? Tx Low Power? ? 20
? ? ? ? ? ? Tx High Power? ?30
?
? ? ? ? Accessory Configuration?
? ? ? ? ? ? Rx Audio Type:? ? ? ? ? Filtered Audio
? ? ? ? ? ? Data PTT Audio Source:? Ext Mic Audio
? ? ? ? ? ? Ext. PTT Audio Source:? Ext Mic Audio
? ? ? ? ? ? Ignition Sense Type:? ? On/Off & Ignition
? ? ? ? ? ??
? ? ? ? Option Board
? ? ? ? ? ? Enable Flat Tx Audio un-checked (If checked no PL is sent)??
? ? ? ? ? ??
? ? ? ? Accessory Pins??
? ? ? ? ? ? 3 External Mic PTT
8 PL and CSQ Detect (Output)
?
??
? ? Conventional Personality
? ? ? ? Basic
? ? ? ? ? ? Squelch? ? ?TPL
Bandwidth? ?25
? ? ? ? ? ??
? ? ? ? Options
? ? ? ? ? ? Tx Power? ? ? ? ? ? ? ? 20 Low or High, depends on radio
? ? ? ? ? ? TOT? ? ? ? ? ? ? ? ? ? ?180
? ? ? ? ? ? Busy Channel Lockout? ? Disabled
? ? ? ? ? ??
? ? ? ? Advanced
? ? ? ? ? ? Compression? ? ?Disabled
? ? ? ? ? ? Expansion? ? ? ?Disabled
? ? ? ? ? ? Emphasis? ? ? ? De-Emphasis and Pre-Emphasis
?
