skipp,
Do you think the specific cable lengths were done for
circuit design, or just convenience of cabinet equipment
installation? Joe
I try not to think too much... but the answer to your question
is just the location in the cabinet.
s.
On 9/22/2018 8:02 PM, skipp025@... [Repeater-Builder] wrote:
> The original RF leads (coax) from the splitters to the dual amplifier
> input jacks was not the same length, same with the output lengths.
> But the total measured length of the input and output cables to
> each external amplifiers was the same. If you can get your head
> around the input cable to amplifier A was the same length as the
> output cable for amplifier B. The converse of the amplifier A output
> cable was the same length as the B amplifier input cable.
