Chuck,
I'd be happy with general instructions on the technique. I'll be
mentioning your lab notebook on my next live stream July 6
th!
73! Mark KA6WKE
Website:
Live Stream:
YouTube Live!:
Author: 4NEC2 The Definitive Guide EMail List::
[email protected]On Thu, Jun 27, 2019 at 7:24 PM chuck adams <chuck.adams.k7qo@...>
wrote:
Mark,
You're right. I did not write it up in the lab notebook
and that is my fault. I thought of it. I thought it through. Just
didn't type it
in.
And, just for reminding me of that fact that it should be in the book, I
will spend
tomorrow doing one for a 1W. Your call. You want it with a digital
display or do
you want one with an audio frequency readout. Can't have both in one
day. :-)
You choose.
chuck, k7qo
On 6/27/19 6:59 PM, Mark Schoonover wrote:
Thanks for the quick response Chuck. Not sure where this lab notebook has
been all my life! It has a section on making enclosures out of PCB but
didn't see anything about Al enclosures. I'll check out Youtube when I
have
time.
73! Mark KA6WKE
Website:
Live Stream:
YouTube Live!:
Author: 4NEC2 The Definitive Guide EMail List:: [email protected]
On Thu, Jun 27, 2019 at 6:40 PM chuck adams <chuck.adams.k7qo@...>
wrote:
I use 0.040" Al. I have section in the lab book and in some youtube
videos under K7QO.
I use a cheap Harbor Freight brake, also documented in both of the
above so that I don't want to take up much room here.
FYI
chuck, k7qo
On 6/27/19 4:26 PM, Mark Schoonover wrote:
Chuck!
What thickness of Al did you use? I take it you have a bending brake of
some sort?
73! Mark KA6WKE
