开云体育

Hi All There has been several contribution on how to create a T-Check for the NanoVNA and I have made a document about why these T-Check are not so promising. It is in fact not possible due to the lag

Hi Lajos It requires the Softmaker freeOffice can handle macros. Looking at the link provided to Softmaker freeOffice it does not look so. Besides there is no such freeOffice on the Softmaker webside

Paul, Your description of the problem is vague at best. However, if you're saying that the display on the screen is the problem, it might not be an nanovna-saver problem If I'm correct in thinking

Ok.?? A quick search mentions Google sheets and IBM Lotus Symphony and a few others as alternatives.?? Maybe someone with experience using zplot can test it on the various free Excel alternatives

connection, and for a VNA, you should be seeking the most repeatable connection possible. Dave

Hi, nanoVNAPartner v0.17 What's new: -S11 and 21 interchanged labels are fixed; -S11 and S21 Min and Max points on Phase and Group Delay are added; -Error on TDR when the main chart is cleared also

I tried ZPLOT on Libre Office V5, no go too. 73 de Andy

Unfortunately, I have not tried to use zplot at this time but since Softmaker claims it is compatible, it may work.? On Sun, 8 Dec 2019 at 1:47 AM, pgc1682@...<pgc1682@...> wrote: Hi

My currently installed firmware allows changing scale of Smith plot, but not center. Perhaps a firmware bug in October overwrote scale and offset...

Hi Rudi The ZPlots has facilities as mentioned before to calculate Z0 as function of Frequency base on measurement of an open and shorted cable. Here is the result for the 33cm cable we are

seems like its dooable then,imworking on making a milled aluminium case for it so the mechanical stuff isnt an issue,was more concerned about the frequency responce,im only going to use it upto 70cms.

Hi Paul, if N is an alternative for you: N provides much better accurate quality for higher frequencies than BNC. See pics: The (slightly hot air bent) extended PE board permits hand isolation: Often

/g/nanovna-users/wiki/BNC /g/nanovna-users/wiki/RF-Calibration%2C-considerations%2C-notes

What Linux distribution are you using? As Nick said, if you follow the installation instructions, the program installs without a problem on Linux Mint 19.2 and works just fine.

And your badly written, ungrammatical "thoughts" are not an answer at all! If you have nothing useful to say, please avoid posting noise.

No: https://www.softmaker.net/down/officecomparison_en.pdf

If you want to move a marker, put your finger or stylus on the trace, and without lifting it, drag left or right. The important bit being "without lifting it". If you lift your finger or stylus, you

To check for newer offerings, I go to /g/nanovna-users/wiki .. then search for software .. then firmware

Hi Bob - Unmodified ST-LINK lacks support for communicating with firmware https://electronics.stackexchange.com/questions/321446/is-it-possible-to-use-st-link-usb-for-uart-communication

Why not? But i dont think they wil fit or the case wil be a lot thinker,maybe if you make a printable box around it Op zo 8 dec. 2019 09:30 schreef paul larner <quadzillatech@...>: