On Sun, Dec 8, 2019 at 01:53 AM, Ray, W4BYG wrote:
Just received my new NanoVNA and beginning to learn how to use it.? I
have read the "user guide" but it is not much help with my problems:
After I set the menu settings for display, frequency, etc., and start
trying to use it, I am having trouble moving the markers to where I want
them on the trace.
As I go to touch a marker to move it where I want it, the menu comes up
automatically on the right and the marker doesn't move. I close the menu
and try again with the same result.? Repeated attempts will eventually
allow me to move the marker, but it is still problematic.
If you want to move a marker, put your finger or stylus on the trace, and without lifting it, drag left or right. The important bit being "without lifting it". If you lift your finger or stylus, you make a tap instead and that brings up the menu.
What am I doing wrong or missing?
Also, is there a setting where I can tell it to boot back up to my last
screen settings, instead of the factory default out to 900 MHz?? This
would allow saving the battery when I have to be make extended changes
to an antenna and not have to reprogram everything again.
If you save your current calibration and range selection to slot 0, it will be loaded when you power on. If you don't want to save to slot 0, save it to another slot and load from that slot via the menu after powering up. The slots save more than just the calibration settings.
Additionally: Is there software for use with a Win 7 or Win 10 PC and
for Android?
See the files section of the group.
Your assistance would be appreciated.
Ray, W4BYG
grizewald