开云体育

From Wiki https://en.wikipedia.org/wiki/SMA_connector SMA connectors are rated for up to 500 mating cycles,[7] but to achieve this it is necessary to properly torque the connector when making the

Dollar Tree sells both for $1.25

Try Amazon. you can get USB C TO USB A. OR USB C to USB C. I have purchased several from them. Clyde KC7BJE

test111 -- *_ . . _ _ _ _ _ _ . _ . .*

Ray, it sounds like you have a device already assigned to COM3. You need to delete it. If your usings Windows open up the Device Manager by right clicking on the Microsoft Logo in the lower left hand

The nanovna uses the USB protocol, so eventhough it looks like a serial port, it doesn't use a baud rate setting. So that shouldn't matter. For reference, though, mine shows the default 38400/8/n/1

Having some trouble getting my NanoVNA-H to talk to NanoVNA-App. The app says it's connected via com 3, but it's not controlling the nano, or exchanging any data to and from it. I've tried several

In Windows 7 the driver has to be manually installed. You can get the driver from my Box account below. Use the 32 or 64 bit version based on your OS. The later versions of NanoVNA Saver do not work

On 2/25/23 5:43 AM, DougVL wrote: > NanoVNA-F for outdoors use, -H for indoors. The little 2.8 inch -H is quite inexpensive, and also works well with PC software (NanoVNA-Saver and NanoVNA-APP),

Hello. If I connect a cable to the NanoVNA and calibrate OSL at the end of that cable, and measure the same cable, I should get 1 small point to the right of the Smith chart when the cable is open, or

Just had that problem yesterday when I tried to upgrade the firmware on my NanoVNA H. Here’s what I did to fix it. 1. I’m Device Manager, right-click the device and select Umimstall 2. Unplug the

Everyone has USB cables these days. Walmart, K-Mart, Best Buy, Lowes, Home Depot, Piggy Wigglie, even some grocery stores........ I even found what I needed in an "all purpose" grocery store last year

Hugen, Is there any downside to removing R98 if my device contains this resistor? Ed, K0KC

Thanks for the response, Manfred! I ordered the -64 version this morning and should receive it this week. I am thinking of investing in a torque wrench as I work myself up in frequency with these

Torque on SMA connectors is very important and touchy. The torque applied to SMA connectors seems to vary between 5 in-lbs and 9 in-lbs depending on where you look. Pasternack sells a really pricey

Now I opened it, and it turns out that R98 isn't present. Since I had it open, I measured battery current while off: It's 0.87mA. At this current it takes two months to totally discharge the initially

I will do that. So far I have been too lazy! ;-)

I found usb-c to usb cable at a dollar store. 0ops … now its a dollar and a quarter store. Chuck KF8TI

Got it done [email protected]> wrote: