开云体育

Look on page 14 here https://www.maurymw.com/pdf/datasheets/2Y-051.pdf There should be a small gap between the female inner conductor and the thickest part of the male - the bit I call the shoulder of

The only android app I know of is this: https://play.google.com/store/apps/details?id=net.lowreal.nanovnawebapp&hl=en_US&gl=US

I am looking to replace my bricked (or as Larry Rothman put it, burnt) original Huygen nanoVNA-H. It appears I have a choice: original Huygen nanoVNA-H at a pretty good price or an original Huygen

Read Grumpy Old Man, I was a family doctor (the old fashioned kind) for 44 years, but sincerely wished I had known about computers and how they worked before I got into medicine. Just the excitement

Further thoughts on the above. As a doctor, I started my training by learning anatomy, physiology pharmacology and biochemistry, before ever going near a patient. I needed to know the basics of how

Dear Chris, I am one of your dinosaurs, at 70, although my career was medicine, not electronics and computing; that became my main hobby from the age of 10. Us old farts do not make fun of the new

Hi Mark, I understand better now. I deleted the device driver that showed up in the USB Devices section when I booted into DFU mode. Once that was gone and the new one loaded, the device showed up in

Stefan, The software just could not find my device. Although I could terminal into the device, the software could not see it. Downloading, installing, and using the previous version resolved that

Do I already have the latest firmware for the H4? Also, how can I tell if my USB cable is data-capable? Also a question on calibration. A calibration guide I read says to add any pigtail cables you

Dr. Dave, Interesting article regarding the connector on the 600. I did NOT know about the gap you speak of between the male and female shoulders... I’m not 100% sure I understand what the

LOL, seriously guys? I’m no young chicken at 57, but I’m also not a dinosaur. I find it interesting the older generation makes fun of the new generation, on a forum site which was made for

You don't have an H, you have an H4. In dfu mode, it has a dark screen. Also, you can get into dfu mode by turning the unit off, holding the jog switch in and turning the unit on. Then, release the

Hi Mark, What were the circumstances that seemed to trigger that particular response in your device?

I'm trying to set up a new Hyugen NanoVNA-H for first use. First task was to charge the battery, and got that accomplished. Next is to update the firmware. I'm trying to follow the "How to Update

FWIW I had the same problem. I moved back to the previous version and then it worked. I'm also using Win10. mark

Dear KC7BJE, perhaps you may find some information in my post /g/nanovna-users/message/17351 from which I extracted the following sentence: Once you have checked that Bluetooth

I have a HC-06 Bluetooth module installed in the VNA. My Galaxy 10S sees and pairs with the modual with no problem. However, I have not found any software for the VNA, Windows or android, that works

Have been looking for a "tinySG" on this thread. Attached below is a posting on the WB-SG1 that can be seen on ebay along with a review. Not very good, just a frequency source. I found this one as

NanoVNA uses si5351 above it's spec and most chips work fine above 200MHz and up to 300MHz, but some are a few MHz short of it. This has been discussed here before and the key is the point where the

The spikes are also present with just a 50 ohm terminated coax ..