开云体育

Having a really hard time imagining how you would "provisionally" attach the nanoVNA to the coax. I highly recommend getting an adapter or pig tail. I have purchased adapters and jumper cables from

Adapters make it easy. But at 27mhz, could use a couple 10cm long test leads with alligator clips to somehow connect braid to braid and center conductor to center conductor. That would work just

provisionally and replacing it with the PL when I'm done? Or do I have to buy SMA to PL adapter? > Get yourself some SMA to PL-259 adapters (actually, what you probably want is SMA to SO-239

Hi Carol, Thanks. I guess any capacitor can be used in order not to block the frequency or better said a capacitor which lets through my frequency of 174 MHz. Right ? Just guessing :-) Rainer

Either of those solutions will work fine.? The only caveat is to be careful not to break loose the connector on the nano.? At 27 MHz you don't need to be very careful about lead length and such. I

A schematic diagram posted a similar thread on Reddit https://www.reddit.com/r/AskElectronics/comments/dj6c4t/nanovna_dc_bias_on_inputs/ shows there is a DC current path through resistors on the

On Mon, Oct 5, 2020 at 08:50 AM, OneOfEleven wrote: On Tue, Sep 29, 2020 at 06:07 AM, Hugen wrote: We have been working closely with Jan and provided all manufacturing support for Jan's second

I'd certainly be interested in buying one when/if they become available.

Hello, I ordered NanoVNA and it should arrive this week. I'm building wire dipole for my CB and I would like to measure its SWR. The problem is that I will be using the PL-259 connector and the

Hi, One more question in regard to my Set up. It is a DIY 4 element YAGI antenna for the frequency of 174 310 000 Hz and the LNA is Bias Tee powered from the connected RTL-SDR receiver. Is there a

Hi Ignacio, Thank you very much. Will do. As I have build a second antenna with the same characteristics as the one which is working I can measure the one which is not installed on the roof and so

Hi Carol, Thank you very much. I will have to dismantle everything then. :-) regards Rainer

You save your test setup exactly the same way you save your calibration - in the same memory slot. Do your cal for the freq span you want to test in and save to slot 2 (for example). Slot 0 is

Hi, is there a way to save one's test settings? I know you can save calibrations in 5 places, but what about the settings for a particular test?

Good evening Gyula, Thank you for the reply and information, very much appreciated. Regards 73’s Gary VK4OO

Hi Chris, Since the creator of NanoVNA Partner does not have his own website, I offered to store the file at the time of creation. So it can also be found in my storage (.rar and .zip) format, as

Yes, if you wish to measure the characteristics of the antenna. No, if you wish to measure the characteristic of the amplifier. Carol

If I understand it correctly, you have a LNA connected to the antenna and the cable connected to the output goes to your shack and you want to measure from there, right? In that case you will measure

Hi, Started this new hobby setting up a RMO station and now I want to measure my DIY 4 element Yagi antenna in roder to optimize it. Is it possible to measure the antenna leaving a Low Noise

Hi, Just entered this interesting hobby of Radio SDR for RMO, DIY Antennas and all that stuff. Got my Nano VNA H today and I have a question. Do I need tot ake off my Low Noise Amplifier for