开云体育

https://www.sdr-kits.net/BNC-3pc-Cal-Kit Only good to 600MHz though. -- Terry VK5TM https://www.vk5tm.com ( https://vk5tm.com )

NanoVNA need ~1-2ms for measure 1 point Pause 0.5ms between measure points for wait si5351 freq lock (can be larger on band change)

Did a search on google using "bnc calibration kit" and had several hits that includes both male and female configurations along with a wide range of cost. -- David S

One caveat to measuring at the end of a long cable is that the calibration and measurement may need to have the sweep speed reduced. A round trip reflection cal or measurement with a 100 M

Hello all- received my nanoVNa from Amazon Sunday, have the Saver software running on win10 ok. Trying to also install on Ubuntu 18.04, but run into problems: ~/nanovna-saver$ python3.7 -m pip install

Don't know whereabouts you are. I bought my nanoVNA-H from Mirfield Electronics here in the UK. Arrived in 4 days, well packed and included a couple of extras adapters for PL259/SO239 in the price.

IN France, we have https://www.passion-radio.fr/appareils-mesure-rf/nano-vna-918.html

In France we have, https://www.passion-radio.fr/appareils-mesure-rf/nano-vna-918.html

Can you name them and/or give their website URLs?

I have been using Aramex Global Shopper (I'm normal client of the company) for the last 3 years - I provide an address in Hongkong for AliExpress and the shipment took 10 days to arrive there from

Mike - That's been going on for 12+ months - I buy from China regularly and have been on several occasions. Generally there's no problems with the stuff leaving the factory but the distribution

In the other direction, there are countries that the USPS isn't even accepting shipments to right now, either because their post offices have shut down or because no transportation is available. Info

No need to speculate based on anecdotal cases: https://www.agility.com/insights/COVID19/air-freight/ There's massive disruption generally, some of us are lucky and some are not. 73s, Hajo PGP key:

Her are some pictures.

Checked your picture, black and white are not made by us, but it seems that your black version uses the same circuit as ours, we only found a little difference on the PCB, as long as the test is

All, I'd like an inexpensive calibration set (open, short, 50 ohm load) for BNC (M&F) Any one seen such?? Larry, K4MLA

Calibrating to the end of a cable was SOP in the lab I ran and every time some one would tell me it introduces error I'd give them what ever time they needed to prove it. They all failed in their

On Tue, 19 May 2020 at 22:36, pez@arg <petrosez7@...> wrote: > | On Tue, May 19, 2020 at 09:48 PM, <sj@...> wrote: > = > | > | I would say NO. > | Sorry to say, but have worked with VNA's for

Thank you. I see it now. My old eyes need some magnification hi... hi Tony VE3DWI. [email protected]> wrote:

They are all taken in the same format! All 4 graphs have both measurements on them. The results are so close that one is directly overlaid on the other and you can't tell one from the other except at