开云体育

Hello Luis, You haven't taken in account your time, your hourly rate. If I did then it's cheaper for me to buy than to make. Not that it will be, I don't need them. Of course it varies but a lot of

Ok if you ask I will answer: Between my junk box and ordered parts I can make from scratch 3 units for under 3usd, with (3) different patterns. If not using junk box it would be 4usd for the 3. It's

Hi Pete, Enclosed is the s2p example as generated by NanoSaver 0.2.1 for a 3S4 type core (6 wdgs, 35mm diameter). This output is : Stim ? Real(S11)?? Imag(S11)?? Real(S21)?? Imag(S21)??

I got two of this test board and made one of them. It worth the cost. Why bother to do from scratch. VR2XHQ

Measuring antennas... Depending if the antenna is balanced like a dipole then a choke balun (1:1 unun)is a must at the antenna as RF on the shield will be painful and inconsistant. Antennas like

Thanks Kurt. I went to Gunthard's web page and I will install the software. My nano will arrive on Monday. -- Ron WA0RJ

Thanks, Tim! -- Ron WA0RJ

I need a toroid balun when I measure anything which radiates. I hope this helps.

I have a short lenght of cable between VNA and Device Under Test. It would help if TDR and VNA had same units. There are formulas, but they need searching, I can't remember them out of my head.

Don't forget if the load is close to or at 50 ohms, the length of you coax means very little as long as the coax length? is reasonable.? So if you measure close to 50 ohms that's what the load is.

hello to be sure is to test as near as possible of the antenna less than one meter. And afterwards to use the coaxial cable. Depending of the nature and the length of your cable, you may find very

Hi Arie, Does Nanovna Sharp output a different format than Nanovna Saver? Just looked at an s2p file from sharp. It appears to be the S21 linear and phase angle. The DUT is 15 turns on a high

Well I have ordered parts to make 3 of these for less than 4USD. And with one of these, I can make different configurations... [image: image.png] You are right, the kit its pre-made, but I have time

Pete, Thank you so much for this information and spreadsheet! Looking forward to use it...! *73 de Luís, CT2FZI* *QRV @ 145.300 MHz | **CQ0VMST (VHF REP Monsanto)* <http://goog_717545661>

Aleks would do that in the language of the forum, ie English. When I log in and write on the Russian forum, I do not write in Hungarian. Thanks. -- *** http://ha3hz.hu/ ***

Pete, Thanks for that! I had already modified the G3TXQ sheet, but yours is nice and simple. One thing I think I shpould mention, your entry fields are: linear(S21) and phase(S21) In the S2P files

On Sat, Apr 18, 2020 at 04:21 AM, CT2FZI wrote: ...If one has that basic soldering skills you could build these for less than 4USD, specially if you just build the test fixture...

"40pin round row seat x2" You cut them to the length required. 73 -Jim NU0C "Oristo" <ormpoa@...> wrote:

To calculate the Z of the DUT between Ch0 and Ch1 (using S21 Series method), I initially used G3TXQ's method after converting from his formats to what the Nanovna outputs. However, I found an Agilent

Does that kit actually include the pictured 7x7 turned pin socket? It is NOT on the packing list...