开云体育

Hello Roger and Larry, Thanks everyone for your support and information. I really appreciate your help. Roger, Yes, I have LiteVNA64, however, I am looking for higher frequency range, and this is the

NanoVNA-App allow select receive calibrated and not calibrated data H/H4 devices by default send calibrated data (this mode for old software) V2/Lite by default send not calibrated data Not shure, but

I thought that but wanted to be sure, thanks!

it does not mess up cause in the app only apps calibration is used and in the device only devices calib is used they do not interact cause the device (even if calibrated) sends raw data over usb

Why not try and share your learnings? -- NanoVNA Wiki: /g/nanovna-users/wiki/home NanoVNA Files: /g/nanovna-users/files Erik, PD0EK

With all the nanovna.app version mod by other people, is there a website that tells what is the difference in them? Thanks

I think this hardware LCD module problem, my LCD on V2Plus4 also have artefacts on screenshots, i replace module, and after this all ok. I can`t solve this by software (i think use different LCD

Also, is it best to not calibrate the nanovna itself and just have the raw data out because a person would be using the nanovna.app to calibrate? I would assume if you calibrate the nanvna AND the

I use the NanoVNA-App v1.1.209 (build by Owen Duffy) together with a NanoVNA V2Plus4 running the current DiSlord firmware (v1.3.07, see first screenshot). I noticed that coloured screenshots look

I had no problem flashing the current DiSlord firmware (v1.3.07, see attached screenshot) onto my V2Plus4 (from the first series of devices sold by nanoRFW) using NanoVNA-App v1.1.209 (build by Owen

The following files and folders have been uploaded to the Files area of the [email protected] group. * /S11.EXE ( /g/nanovna-users/files/S11.EXE ) *By:* Brian Beezley

This VNA product has its own PC program and they have not published their communication protocol. So it does not work directly with NanoVNA Saver or NanoVNA app. You would have to "sniff" the USB

You want a Linux compatible way to calibration from raw data? You might look at SciKit-RF - a python package that does all the needed calculations, as well as drawing plots/smith charts, etc.

My fork for this App: https://github.com/DiSlord/NanoVNA-App Autor write it on C++ Builder (Use free Embarcadero? C++Builder) https://www.embarcadero.com/ru/products/cbuilder/starter/free-download

Khalid, Unless the manufacturer has claimed this device uses a command structure that is compatible with the NanoVNA & LiteVNA series, you will have to write your own interface routines in NanoSaver.

Nick, Nanovna-App is opensource and available on github: https://github.com/nlroth/NanoVNA-App-D Feel free to port it over to Linux - if you dare.....;-)

Like the raw data calibration facility. Can this application be built on linux?

Ok I am going to give it a try I will flash using nanovna.app (I won't be able to save what I got on the unit now) your firmware that was post a few messages back, and I will use your modded software

On LiteVNA (or V2 modded by SD card + my fw) possible dump firmware to card from Expert Settings. For V2Plus4 only if use ST-link. After hold button and power on, you see only black screen, but on

Yes I found it in the menu, and when doing the hold right button the display won't say DFU mode just a white blank screen correct? I won't be doing the ST-link programmer way :( I was hoping there was