Hi Rune,
Many thanks again for your ongoing development of nanoVNA-Saver - fabulous work!
I am not sure if I should waste your time reporting this as it is not a significant issue....just apple polishing.
I noticed when I first start version 0.2.0 that the Center, Stop and Span frequency info within "Sweep Control" section overflows the window widths. At startup it displays 9 digits as shown below. Once I enter new sweep control frequencies it displays normally. However Center still overflows just a little. I have my sweep Stop set at 850M and the Center is showing 425.025MHz which just exceeds the window width by about a half digit. With initialization the data is about twice as wide as the window width with the most significant digits hidden from view then it reverts to normal upon receiving a new manual frequency entry.
Initialization displayed data:
SPAN 849.949952MHz
STOP 849.999952MHz
CENTER 425.024976MHz
Hope this feedback is useful.
--
Best Regards,
Tom
VA7TA
