Preferably, with a 50 ohm load on both ports. If you only have one, put it
on "ch1" (port 2 - confusing numbering).
Isolation tries to establish and cancel out the base level of noise in the
passive channel of the device.
(At least that's how I've been taught it)
--
Rune / 5Q5R
toggle quoted message
Show quoted text
On Mon, 14 Oct 2019 at 19:10, sala nimi <sala.nimi@...> wrote:
I am using NanoVna saver software and the last action in the calibration
dialog is "isolation". How do I do it or how it differs from "open"
calibration?
Regards
LM
