DMR_M_10KHz_sept-13-19.dfu
Such as these were for enhancements, in this case 10KHz instead of 50KHz
minimum.
I >>guess<< many enhancements are in Gen Hu Oct 2 firmware"
- Should this be installed before or after the firmware?
Any .dfu installed becomes the only firmware, replacing previously installed firmware.
- Which firmware can be used to set an impedance different than 50 Ohm?
I know of none. No real benefit, since reflection bridge components are fixed for 50 Ohms.
Firmware based on different calibration impedance would improve neither sensitivity nor accuracy.
Oristo