Hi Larry,
you're right - the application still thinks at that point that the NanoVNA
is connected - despite having just received an error that it was
disconnected. It should probably just disconnect when it gets the error.
I'll put it on the list of little niggles ;-)
Thanks for the feedback!
--
Rune / 5Q5R
toggle quoted message
Show quoted text
On Wed, 2 Oct 2019 at 19:10, Larry Rothman <nlroth@...> wrote:
Hi Rune,There is a small bug in the serial connect routine.If I disconnect
the Nano while scanning, I get the pop-up error and that's OK.If I then
click on the Rescan button, the selected serial port disappears but the
button underneath still shows "Disconnect".I think if there is no serial
port shown, that should be reset as there is no recovery that I can see -
'Saver just hangs.
Regards,Larry
