I am confused. A friend of mine and I are trying to figure out why *my
nano H4 and his very early nano vna with the 2.8" screen will both run on
his nano saver 0.3.7.* His 2.8 nano runs on my computer on saver 0.3.8 but
mine does not. My w10 system complains about
*Error during sweep*
*Stopped*
*Failed to read data 1 10 times*
*Data outside expected valid ranges, or in unexpected format.*
*You can disable validation on the device settings screen.*
This just happened in the last couple of days. I have both 0.3.7 and 0.3.8
on my W10 system and this problem exists on both saver versions.
Help
Fred - N4CLA
toggle quoted message
Show quoted text
On Thu, Dec 17, 2020 at 9:00?AM GM4OSS <stevegm4oss@...> wrote:
Hi
I'm new to this group and just received a nanovna H4. When I launch nano
saver V 0.3.80 on (W10 PC) it sees the H4 (Com 5) and after I click
'Connect to Device' the software crashes.
I did notice from the nano-saver.exe the following message before crashing.
'Did not recognise nanovna device from firmware'.
Help please - is there a work around?
--
73 de Steve GM4OSS
