On 10/5/22 3:16 PM, hopkor@... wrote:
I am trying to automate my project. For this, I would need to read the stored calibration data from the device and save it to my pc, and then load it back when necessary. Preferable to automate this process using MATLAB/commands. I was wondering in which registry the calibration data stored are stored in nanovana and how can I read and write to it after connecting the device using matlab.
You're better off doing the cals on the PC and sending a reset cal command to the NanoVNA
- Take a look at the python code in NanoVNA-Saver for an example. It uses scikit-rf.
I'm sure there's equivalents to the python Scikit-RF as a Matlab toolbox.
