On Fri, Mar 4, 2022 at 02:51 PM, Stan Dye wrote:
Once you do an SOL calibration at the nano pigtails, over your frequency
range of interest, save it to memory 0. The nano initializes to this when
you turn it on, so you don't need to repeat the SOL each time.
The point of Kenneth's (rightful) response was "calibrate each of your coaxial runs to antenna, recall that later. With more then 4 antennas that's not possible due to nano's limit to slots
On the other side, calibrating at the port is what I do, but I expect that can be done by a firmware/hardcoded value and recalled as needed. I use slot 0 for some other stuff sometimes :)
