On 7/1/2021 9:18 AM, Jim Lux wrote:
On 7/1/21 7:13 AM, Joe WB9SBD wrote:
I do not understand why a good 75 ohm calibration load would not make
the thing be a 75 ohm test.
Isn't that what the 50 ohm one is doing when you calibrate the dead
short and the 50 ohms load?
exactly.
I'd do the cal at the end of the coax, too.
Ok, but I can't do both, the cal is which ever one I do last. Yes, there
are memories, but then which cal means what?
Mikek
--
This email has been checked for viruses by Avast antivirus software.
