Thanks,
I ran a calibration and saved to all 4 locations as you recommended and it is responding properly.
Could it be I entered bad data by setting the start frequency at 10kHz instead of 50kHz?
I an presetting the configurations so that I can use the NanoVNA as portable test sets without a laptop since I do lots of portable operation.
Mike N2MS
toggle quoted message
Show quoted text
On 02/21/2021 11:30 AM DiSlord <dislordlive@...> wrote:
For recall need only use
RECALL->RECALL 0
or
RECALL->RECALL 1
and e.t.c
if device hang on recall - possibly problem in bad data on it, try reset config and clear settings (use console and run 'clearconfig 1234').
Or you can save some valid data in all slots
After start save data on all slot:
CALIBRATE->SAVE->SAVE1
CALIBRATE->SAVE->SAVE2
CALIBRATE->SAVE->SAVE3
CALIBRATE->SAVE->SAVE4
