|
Sorry, but the 'Saver app does not have that softswitch - only the Nanovna-APP by OneOfEleven.
toggle quoted message
Show quoted text
You can try that application - get it from the releases area here: It is set up by context menus - hover mouse over just about anything and right-click. Enjoy! On Wednesday, January 20, 2021, 2:11:52 p.m. EST, John Owen-Jones <joj006@...> wrote:
Hi Larry - thanks for the quick reply - it¡¯s the Nanovna-saver SW - couldn¡¯t see any soft switch on the SW that I have - but then I¡¯m a newbie to this SW so still finding my around the SW settings. .....John In dubio, abstine On 20 Jan 2021, at 18:47, Larry Rothman <nlroth@...> wrote: ? John, What's the name of the PC s/w you're using? There are a few of them. If it's the Nanovna-APP s/w, be sure you didn't disable the calibration data - there's a soft switch along the top of the display. ...Larry ? On Wednesday, January 20, 2021, 1:40:51 p.m. EST, John Owen-Jones <joj006@...> wrote: Hi - I¡¯m a new user and successfully loaded the latest version of Dislords firmware on a new Nanovna-H4 and installed the latest version of nanovna-saver on a W10 pc. The nanovna-H4 worked a treat standalone on Ch0 on an antenna right after calibrating and saving in the range 50kHz to 900MHz. I then successfully connected it to the PC SW and after calibrating over the 70cm band I successfully scanned the same antenna with good results displayed. Unfortunately, while viewing the output swr plot I used the mouse wheel to see what effect it had and the frequency range shown on the graph changed but seemed to lock up at a low setting. I re-scanned the antenna but this time I could not get the correct frequency range shown on the graph? display with an error message warning data out of range. I re scanned with only SWR chosen in the display settings but same again. I have tried in vain to get it working correctly since, including calibrating and scanning? over 50kHz to 900MHz rather than the 70cm band. I thought I¡¯d fire up? the saver software again but it still comes up with the same message after scanning. The two data columns seem to show that the scans ran successfully, it¡¯s just that the display fault shows every time with no swr plot and the frequency range stuck at a low setting. Is it possible to reset the sw defaults and start again with any saved settings restored to default or is it a different problem? The nanovna-H4 still works ok standalone and comes up with the correct calibration settings when switched on. I have searched the forum for clues but found none that really helped. Any help would be very welcome. Thanks - John, EI1EM In dubio, abstine |
