On Sun, Nov 8, 2020 at 08:23 PM, Stan Dye wrote:
Two simple notes to consider adding:
- The firmware gives reasonable defaults for the scale and reference line
for many use cases, so you only need to set them if you need them to be
different.
- When you save a calibration, it also saves the display settings, so you
can easily recall the whole setup.
(I note these because the list of setup tasks for each measurement seems
long and maybe intimidating if I have to do them for every measurement -
but it's not nearly as bad as it seems.)
Stan KC7XE
Very good idea. I will do that. Thank you Stan.
Also I have corrected some misspelled words - thank you Mike.
Martin 9A2JK
