I have not yet tried mine using SAVER. However, due to different
architecture and oscillator, I was/am under the impression you need an
application different than that embodied in SAVER. According to my notes,
that can be downloaded at:
Dave - W?LEV
On Wed, Oct 7, 2020 at 7:20 PM Ted Chesley <tedchesley@...>
wrote:
Martin, I upgraded my SAA-2N FW to ver 20200926, works fine on
instrument, however I have the same issue with NanoVNA-Saver, as well
as some other anomalies (program sweep runs on 1 step but hangs on 2
steps). NanoVNA-QT works OK except that low freq stimulus won't
calibrate below 100Khz, but is fine to 3000Mhz (101 steps).
I haven't seen but one other post reporting the same issue with Saver
and the SAA-2N..
-----------------------------------------From: "Martin V via
groups.io"
To: [email protected]
Cc:
Sent: Wednesday October 7 2020 10:31:26AM
Subject: Re: [nanovna-users] nanovna saver on saa-2N
I have the same issue.
VNA 2_2 Version: git-20200617-1a9a11d
Build Time: Jun 19 2020
--
*Dave - W?LEV*
*Just Let Darwin Work*
