Greetings All,
I would like to thank the authors of the subject document which IMHO clearly describes how to get started with the nanoVNA - it is a very helpful document!
I think I noticed a minor typo in ~Note 6~ which is as follows:
"Note 6:
Connect the two equal length Male-to-Male coaxial cables to CH0 and CH1 of the NanoVNA
with the Female-Female SMA connected to the free end of the cable connected to CH1. Dress
these cables away from the NanoVNA in a parallel line and do not let them cross."
I believe the intent was to state that the Female-Female SMA should be connected to the free end of the cable connected to CH0 not CH1 as stated.
The authors may wish to make a correction if appropriate.
Thanks again for this helpful document!
--
Best Regards,
Tom, VA7TA
