Re-calibrating my H4 and my SAA-2N with Nano-saver and VNA-QT (VNA-QT
on the SAA-2N only), , I find an issue with using the nanoVNA-saver
with the SAA-2N that is dogging me. The saver works fine with the H4,
but when connecting to the SAA-2N, on initial connection via USB the
frequency range loads as 200-300MHz. I change it to the instrument
width (10kh to 3000Mhz, it will not sweep, returns: " ERROR during
sweep...stopped....argument out of range". Experimenting with
frequencies, I find that I can sweep and calibrate in a range of 10mhz
to 1000mhz, everything works fine, but if I either lower or raise the
frequency outside that range, I get the same out of range error.
Any suggestions would be greatly appreciated.
