K5MFP de CT2FZI
How are you doing?
I have purchased the H4 case from the OP to encorage and thank him for his
work, however its not hard to do.
I have designed the "yellow" attachment to hold the nanoVNA-H4 with its
case. If i detach it (to use the SMA connectors) , it still inside the
case, thus the 2 parts.
The connectors are 2 x so239 to SMA female adapters followed by 2 x sma
male to male adapters.
[image: image.png][image: image.png]
Don't forget to calibrate your VNA with all these adapters already fit, for
correct readings...
*73 de Lu¨ªs, CT2FZI*
*QRV @ 145.300 MHz | **CQ0VMST (VHF REP Monsanto)*
<>
<>
On Wed, 13 May 2020 at 18:28, Michael Payne <michael.f.payne@...>
wrote:
Hello! I made a case for my nanoVNA, but after seeing your case with the
end that supports the fixed connectors, I decided that would be what I
would like for my VNA. My enclosure is less than 4 inches (10.16
centimeters) wide. Could you tell me how I can replicate the entire case
that you have, and I'm especially interested in the SMA to SO-239
connection. Is the connection hard metal or cable, or what?
I sure want to duplicate the case and connectors like you have shown.
Thanks,
K5MFP
CT2FZI
