On Sun, Jan 26, 2020 at 12:34 PM, Oristo wrote:
Sorry. I should have said "worse clone reported about -72 Ohms reactive and 1 Ohm resistive"
See attached image for repeat of Herb's steps with slightly different results, but still no "j".
My point was, those steps work fine for roughly sorting characteristic impedances,
which firmware in my nanoVNA does not directly report
==============================================================
Oristo,
Would you substitute Andy's message # 10256 for mine in the wiki applications notes? His general procedure is the same but Andy does a much better job than I did of explaining the steps and not confusing the issue by using incorrect terminology.
Much appreciated.
- Herb
